KIWI デザインカバーケース DJI Osmo ポケット用 シリコン保護ダストカバーケース スキン DJI Osmo ポケットアクセサリーとの互換性あり

... but a bit fiddly to fit.This is what the supplied Osmo Pocket case should have been like. It gives your camera much, much better protection in your pocket or bag, and out and about has the advantage of giving your camera some reasonable protection from rain showers.It IS a bit fiddly to fit but if you take your time, and maybe even warm the new case on a radiator for half an hour before trying, and persevere gently it will suddenly just slip into place. Don't keep forcing it and jabbing hard as you may damage the rubber edges that you need to keep the new cover in place - or worse, damage the original DJI case that this cover fits to - just keep going gently and you will succeed eventually. It took me about 20-25 minutes to get it fitted after about a dozen failed attempts where it seemed to be going in then slipped out at the last minute.So yes, it is a bit frustrating to fit, but once its on it is pretty much perfect.Design-wise my only criticism (and the reason fro dropping one star) is that the little compartment inside the top of the cover that is supposed to be for holding filters is a little to big/deep. Filters rattle around in it, and if you've got expensive filters you probably won't want to risk them getting scratched in there by bumping into each other.One other thing to note is that even with this extra cover on the case, the whole thing still fits into the cutout of a   without any problems.Wholeheartedly recommended.

A very well thought out design by KIWI Design! They have taken the standard case that comes with the Osmo Pocket and made it into a proper full case without compromising the small form factor of the original, and I love it!Made from the same soft touch silicone as the standard case strap but still very robust and shock resistant. My only teeny gripe is that the 'compartments' for your lenses don't have any foam or similar material to stop your lenses rattling about inside the case. I guess not a lot can happen to such small lenses and it's not a deal breaker but small slots or some foam would be nice. However, this case is great, still pocketable and with the KIWI Design cover case, it will keep out any dust, dirt and water and this should have been how DJI did it in the first place ! I've (hopefully) uploaded a short YouTube video .. just search for "KIWI Design Osmo Pocket O2 Cover Case" :-)

When I ordered this I didn't realise it is only one half of a case, you use the original case that came with your osmo pocket and modify it very slightly (non destructive) you can always go back to the original case.The next bit was the tricky bit inserting the little rubber "flap" through the gap in the original case had me slightly frustrated but after watching the construction video over and over again, I had been trying to do it the wrong way slide the top bit in first as far as it will go the use the provided tool to tease the rest in.When it's done it provides great all round solid protection for you osmo pocket, I think even if you dropped it you would suffer no damage to your osmoI like the fact there is a "concealed " compartment to carry either nd filters or spare osmo connectors.It is good that is has a bung at the bottom to protect dust or moisture getting into the usb slot, just shove it in you pocket and forget it.Great little case highly recommended and here is my assembly tip the case is quite hard rubber making assembly tricky but I put mine in my airing cupboard overnight the heat softened it and I then had no problem putting it together took all of 30 seconds after warming it up