超歓迎 ACDelco FW299 GM Original Equipment あすつく Front Wheel Hub Studs Speed Bearing with Assembly and Sensor

ACDelco FW299 GM Original Equipment Front Wheel Hub and Bearing Assembly with Wheel Speed Sensor and Wheel Studs

Wheel,with,and,Sensor,Speed,Wheel,車＆バイク , カーパーツ , 電子パーツ , ミッションコンピューター,Wheel,Equipment,ACDelco,FW299,Studs,Bearing,12356円,and,Assembly,Original,hartleypharm.com,GM,Front,Hub,/membral1502787.html Wheel,with,and,Sensor,Speed,Wheel,車＆バイク , カーパーツ , 電子パーツ , ミッションコンピューター,Wheel,Equipment,ACDelco,FW299,Studs,Bearing,12356円,and,Assembly,Original,hartleypharm.com,GM,Front,Hub,/membral1502787.html 12356円 ACDelco FW299 GM Original Equipment Front Wheel Hub and Bearing Assembly with Wheel Speed Sensor and Wheel Studs 車＆バイク カーパーツ 電子パーツ ミッションコンピューター ACDelco FW299 GM Original Equipment 【あすつく】 Front Wheel Hub Studs Speed Bearing with Assembly and Sensor 12356円 ACDelco FW299 GM Original Equipment Front Wheel Hub and Bearing Assembly with Wheel Speed Sensor and Wheel Studs 車＆バイク カーパーツ 電子パーツ ミッションコンピューター ACDelco FW299 GM Original Equipment 【あすつく】 Front Wheel Hub Studs Speed Bearing with Assembly and Sensor

12356円

ACDelco FW299 GM Original Equipment Front Wheel Hub and Bearing Assembly with Wheel Speed Sensor and Wheel Studs

ACDelco FW299 GM Original Equipment Front Wheel Hub and Bearing Assembly with Wheel Speed Sensor and Wheel Studs

Original equipment. Great quality. Easy install. I highly recommend.
I unfortunately have to write a poor review of this product.First: The ABS is far too short. It actually pulls on the harness to get this cable to reach, the two insulated wires are also exposed and outside of the protective wrap at the end of the connector by about half an inch.Second: Out of the two units I installed, one of them had a defective ABS sensor right from the start. Causing my slip protection to activate while on the highway, my brakes to smoke and then ultimately my car turning off ECS until the units were removed and the electrical reset.Third: They are not even as snug inside the knuckle as other aftermarket parts. I assume this might be the cause of the brake squeel I get on turns.I really wanted to go OEM, and it seems aftermarket parts (all made in china now) fail way too quickly. But I am going to have to just stick to the aftermarket.
Wonderful fit great, after the dura hubs was making noise right after the install I decided to go OEM!